Click To Call(656) 254-3471Click To Get A Free Estimate
Sealed paver driveway at a single story home in Tampa

Deeper color, tighter joints and easier upkeep

Paver Sealing in Tampa, FL

Tampa driveways, pool decks and patios can get their color back, starting with a call to (656) 254-3471.

  • Brings out deeper paver color
  • Fresh joint sand helps lock pavers in place
  • Gives weeds less room to grow
  • Makes the surface easier to keep clean
  • Free estimate, no obligation

Request a Free Estimate

Free, no obligation.

Step 1 of 2

Where are your pavers?

Please choose one.

Free EstimateNo obligation
Fast ReplyWithin 1 business day, usually much sooner
Typical Local Price$1.25 to $2.50 a sq ft to clean, sand and seal
Call Now(656) 254-3471

Who can seal pavers at my Tampa home?

A local contractor seals pavers across Tampa, FL, and a reply reaches you within 1 business day, often much sooner. The estimate is free and booking stays your call. Begin by calling (656) 254-3471.

A coat of sealer deepens paver color, holds joint sand in place and lets a hose rinse off dirt and algae. Think of your driveway after a muggy summer, gray along the edges and thin on sand, then dark, even and full again. Driveways carry tire wear and oil while pool decks see splashing and bare feet, so each surface gets its own plan. Note how each area gets used, then ask for a free estimate.

Call (656) 254-3471

Contractors sealing a brick paver driveway with a sprayer and a roller
What's included

What is included when pavers are sealed in Tampa?

A sealing job has four parts: a look around, a deep clean, joint sand and the coat itself. Washing takes the most hours. For the details at your address, call (656) 254-3471.

Walk-through

Square footage, sunken spots, broken pavers, old sealer and puddles are written down before a price is set.

Deep clean

Algae, dirt, rust and leaf stains come off with cleaners matched to each, then a gentle wash.

Joint sand

Sand packed into each gap keeps the pavers locked and leaves weeds little room.

Sealer coat

The product is applied to dry pavers in light, even coats, following the label's coverage rate.

How can I tell my pavers need sealing?

Watch for chalky color, joints that sit below the paver edges, sand scattered after a storm and water that sinks in instead of beading. Topping up sand soon is cheaper than resetting pavers that have shifted. For a quick opinion, call (656) 254-3471.

Which paver sealer works well in Tampa's humidity?

No single product fits every home, so ask the contractor to name the sealer and explain the choice. A Tampa Bay pressure washing company lists water-based sealers as the cheapest, solvent-based ones as glossier and costlier, and urethane as the priciest and longest lasting. To compare options for your pavers, call (656) 254-3471.

Unilock, a paver maker, says its pavers perform without sealer, yet a coat can deepen color, keep sand in the joints and guard against moisture and stains. That is a fair description: a coat helps with upkeep and does not repair damage. Ask how each product would look and wear on your surface when you ask for a free estimate.

Should I choose a wet look or a natural finish?

Pick wet look for richer color and shine, or natural to stay near the stone's original look. A Tampa Bay company calls wet look the finish homeowners request most. It scuffs sooner and can feel slick when damp, so a pool deck or busy driveway may suit a calmer sheen. Request a small test patch of both when you ask for a free estimate.

How often should pavers be sealed in Tampa?

Quotes around Tampa Bay range from every two to three years to every three to five. Family Handyman also suggests three to five years. Full sun, sprinklers and daily car traffic push a driveway toward the short end, and a covered patio can last longer. Water that soaks in instead of beading suggests the coat is spent. Call (656) 254-3471 to have it checked.

Does more sealer mean more protection?

It does not. Unilock cautions that heavy or uneven application can leave haze and lap marks. Be careful with any offer built around extra coats, and ask about the coverage rate before you ask for a free estimate.

When is the right time to seal pavers in Tampa?

Pick a dry stretch long enough for the coat to cure. Unilock asks for 24 to 48 hours of dry weather, sprinklers turned off and temperatures between about 50 and 90 degrees. Tampa's wet season runs from late May to early October, so the dry months give longer windows. To pick a date around the forecast, call (656) 254-3471.

New pavers have to wait. Unilock advises holding off until efflorescence clears, usually two to three months and sometimes up to a year. For a recent install, mention the date when you ask for a free estimate.

Will sealing fix sunken pavers?

Sealer cannot lift pavers that have sunk or drifted from the edge. Those spots have to be leveled before sealing, so ask if the quote covers that. Joint sand comes in a few shades too, and a close match looks more even. Raise both topics when you ask for a free estimate.

Contractor with a clipboard walking a Tampa homeowner around a paver driveway
Surfaces

Which paver surfaces can be sealed?

A coat can go on driveways, pool decks, patios and walkways alike. Each one wears in its own way, so the plan depends on how the space is used. To start with yours, ask for a free estimate.

Driveways

A driveway takes tire marks, oil drips and the hottest afternoon sun on the lot. Sealing pays off most at the spots where tires turn and seams open up.

Pool decks and lanais

Pool pavers get splash water, chemicals and bare feet every day. Sealing a deck should leave good traction behind, not a slick film.

Patios

A patio under oaks or beside a fence stays damp and collects leaves. Sealing a spot like that takes the most scrubbing.

Walkways and entries

Front walks pick up mulch, soil and sprinkler spray. Sealing a walk is a small job, yet it is the first thing a visitor steps on.

Common problems

What paver problems are common in Tampa?

Five problems keep showing up on Tampa pavers: fading, green growth, lost joint sand, sprinkler streaks and failed old sealer. Call (656) 254-3471 to have yours inspected.

1. Color baked out by the sun

July highs in Tampa average 91 degrees, and an open driveway takes that every afternoon. Bare pavers turn chalky first, and a fresh coat slows the fading.

2. Green growth in damp corners

Shade, a roof edge or a hose bib keeps one corner wet through the long wet season. Algae moves in and the stone gets slick, which matters on a pool deck or front step.

3. Sand pushed out of the joints

Summer storms are heavy and short, and they flush sand from the seams. With the joints low, pavers can shift and weeds take root.

4. Sprinkler and rust streaks

A spray head aimed at one edge leaves orange or gray marks. Those need their own treatment before any sealer goes down, or the coat locks them in.

5. Cloudy or peeling old sealer

A coat that trapped moisture can turn milky or flake. It has to be dealt with first, and a water-based product should not be laid over a solvent-based one.

Pricing

What does paver sealing cost in Tampa?

Sealing in Tampa commonly runs $1.25 to $2.50 per square foot to clean and seal, according to one Tampa Bay paver company. Another Tampa company lists $1.50 to $3.00. Size sets the price first, and the state of the stone comes second. Stained pavers, sunken sections and failed old sealer take more labor. To get a figure for your own home from these ranges, ask for a free estimate.

Size matters in a second way. That same company says a small patio can price near $3.00 per square foot, while a 2,500 square foot job can come in near $1.25, and small jobs often hit a minimum of $500 to $1,000. Call (656) 254-3471 to ask how a contractor handles a small area.

Not ready to seal? The paver cleaning and joint sand guide explains a stand-alone wash. The service area list and the paver sealing in Tampa home page are one click away.

Paved areaTypical exampleClean, sand and seal
300 sq ftSmall patio or walkway$375 to $750
600 sq ftTwo car driveway$750 to $1,500
1,000 sq ftLarge driveway or pool deck$1,250 to $2,500
1,500 sq ftDriveway plus pool deck$1,875 to $3,750

Math based on the $1.25 to $2.50 per square foot that Tampa Bay paver companies publish. Your contractor sets the actual price after seeing the surface. Repairs, leveling and stripping failed sealer are usually extra.

Get a Free Estimate

Paver pool deck beside a screened pool in Tampa
Why choose us

Why use a local contractor for paver sealing?

A local contractor is used to the heat, rain and shade your pavers deal with. Have the price put in writing and take as long as you like. To get going, call (656) 254-3471.

A contractor who knows the area

A company that works around Hillsborough Bay and the neighborhoods behind it has seen how sun, storms and shade treat pavers here. Your first visit starts further along.

A free price and no pressure

The estimate costs nothing, and any deal is made with the contractor directly. If the number does not suit you, you can simply say no.

A range to check bids against

Tampa Bay paver companies publish their rates, and the range is on this site. A bid far outside it deserves a second look.

You choose the pace

Get the plan on paper and take a few days to decide. The contractor standards page covers what to confirm before saying yes.

How do I get a free paver sealing estimate?

Phone or use the short form, and expect an answer within 1 business day, frequently sooner.

Call (656) 254-3471

Free, no obligation

Even colored pavers with full joints just after a sealer coat
Photos

What does a finished paver sealing job look like in Tampa?

Freshly sealed paver driveway at a Tampa home
Sealed paver pool deck at a Tampa home
Sealed paver patio behind the home at a Tampa home
Sealed paver walkway to a front door at a Tampa home
Close view of freshly sealed pavers at a Tampa home
Paver area with one cleaned half beside a dirty half at a Tampa home
Contractor cleaning pavers at a Tampa home
Contractor sealing or sanding pavers at a Tampa home
How it works

How does the paver sealing process work?

Five steps make up the paver sealing process, starting with a measured inspection and ending with a walk around the finished work. To reserve a slot, call (656) 254-3471.

1. Measure and inspect

The contractor measures the area for the sealing quote and notes sunken spots, loose pavers, old sealer and any place water collects.

2. Cover and treat

Shrubs, pool cage screens and the garage door get covered, and the irrigation goes off. Algae and stains get a cleaner suited to each, tested on a small patch first.

3. Wash with a surface cleaner

A rotary surface cleaner works across the stone at a gentle setting, near 1,500 PSI according to Western Interlock, so the joint sand stays in place.

4. Refill the joints

Once the pavers have dried, new sand is swept in and settled. That locks the stones together again and leaves weeds less room.

5. Seal, then walk it with you

If sealer is in the plan, it goes on dry pavers with a sprayer and a roller. The contractor then walks the finished area with you and tells you when feet and cars can return.

Questions

Frequently Asked Questions

Is it better to spray or roll paver sealer?

Many contractors do both. A sprayer covers ground quickly, and a roller afterward smooths puddles and drips. Unilock lists a sprayer or a foam or short pile roller as options. Even coverage matters more than the tool, so ask how your contractor plans to apply it.

What is the average cost to seal pavers in Florida?

One Tampa Bay company publishes $1.25 to $2.50 per square foot to clean and seal, and another lists $1.50 to $3.00. A 600 square foot driveway in Tampa would fall near $750 to $1,500 on the first range. Repairs and stripping old sealer are usually extra.

What are the downsides of sealing pavers?

The cost comes back every few years, and a glossy finish shows scuffs sooner and can feel slick when wet. Sealer applied over damp stone can also turn cloudy. A dry window and a finish chosen for each area head most of that off.

How often should I seal pavers in Florida?

Quotes around Tampa Bay run from every two to three years up to every three to five. Open driveways and pool decks fall near the short end, and covered patios can go past it. Saltwater pools and frequent summer storms shorten the span.

What should I clean pavers with before sealing?

That is the contractor's call, because algae, rust and leaf stains each respond to a different cleaner. A careful company tests the cleaner on a small patch and washes at low pressure. Ask what product they plan to use and how they protect plants.

How much does it cost to have your pavers sealed?

Expect $1.25 to $2.50 per square foot on the range one Tampa Bay company publishes. Small patios are often priced higher per square foot, since travel and setup are spread over less area. One Tampa company puts its minimum charge at $500 to $1,000.

How long should I stay off pavers after sealing in Tampa?

Plan on about 24 hours for foot traffic and 48 to 72 hours before parking on the surface, according to a Tampa Bay paver company. The contractor will tell you the exact time for the product used.

Will an afternoon storm ruin newly sealed pavers in Tampa?

It can, if the rain comes before the coat cures. Unilock asks for 24 to 48 hours of dry weather. Tampa's wet season runs from late May to early October, so contractors watch the sky and move the day when needed.

Can a pool deck in Tampa be sealed?

Yes, and many are. Ask which product the contractor suggests for a surface that stays wet under bare feet, and whether a slip-resistant additive can be mixed in.

Ready to bring your pavers back to life?

Describe the driveway, deck or walk to a contractor as it looks now. You hear back within 1 business day, usually much sooner, and the estimate costs nothing.

Call (656) 254-3471

Free, no obligation